Brother MFC-J4410DW - Scan to OCR

Network Scanning
199
13
l Press Start.
The machine starts scanning the document.
NOTE
You can change the Scan button settings using your Brother machine - however, these changes are only
temporary. If you want to make permanent changes, use the ControlCenter software. (For Windows
®
, see
Configuring the Scan button settings on page 73 when choosing Home Mode, and see Configuring Scan
button settings on page 88 when choosing Advanced Mode. For Macintosh, see Configuring Scan button
settings on page 165.)
Scan to OCR 13
When you choose Scan to OCR, your document will be scanned and sent directly to the computer you
designated on your network. The ControlCenter software will launch the Nuance™ PaperPort™ 12SE
software or Presto! PageManager and convert your document into text that can be viewed and edited from a
word processing application on the designated computer.
For MFC-J4510DW 13
a Load your document.
b Press (Scan).
c Swipe left or right to display (to OCR).
d Press (to OCR).
The icon moves to the middle and is highlighted in blue.
e Press OK.
f Swipe up or down, or press a or b to display the computer you want to send to.
g Press the computer name.
If the LCD prompts you to enter a PIN number, enter the 4-digit PIN number for the computer on the LCD.
Press OK.
Do one of the following:
 If you want to use the default settings, go to l .
 If you want to change the default settings, go to h.
NOTE
If you want to save the computer as a shortcut, press Save as Shortcut.
h Press Options.
i Press Set with Touch Panel.
Press On.