Home > Fax > Receive a Fax > Remote Fax Retrieval > Use Your Remote Access Code
Use Your Remote Access Code
1. When away from your Brother machine, dial your fax number from a touch-tone telephone or fax machine.
2. When your machine answers, immediately enter your three-digit Remote Access Code, followed by *.
3. Your Brother machine signals if it has received faxes:
• One long beep - the machine received at least one fax
• No beeps - the machine has not received a fax
4. When the machine gives two short beeps, enter a command.
• The machine will hang up if you wait longer than 30 seconds to enter a command.
• The machine will beep three times if you enter an invalid command.
5. When finished, press 9, and then press 0 to deactivate your machine.
6. Hang up.
• If your machine is set to [Manual] mode and you are using Remote Retrieval, wait for about 100
seconds after your fax number starts ringing, and enter your Remote Access Code within 30 seconds.
• This feature may not be available in some countries or supported by your local telephone company.
Related Information
• Remote Fax Retrieval
• Set a Remote Access Code
333
To Next Page
Loading...
Need help?
General
