Brother MFC-J6710DW - Basic Operations; Volume Settings; Ring Volume

Chapter 1
8
Basic Operations 1
The following steps show how to change a
setting in the machine. In this example the
Mode Timer setting is changed from
2 minutes to 30 seconds.
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Mode Timer.
d Press d or c to choose 30Secs.
Press OK.
You can see the current setting on the
LCD:
Note
Press Clear to go back to the previous
level.
e Press Stop/Exit.
Volume Settings 1
Ring Volume 1
You can choose a range of ring volume
levels, from High to Off.
While the machine is idle, press d or c
to adjust the volume level. The LCD shows
the current setting, and each key press will
change the volume to the next level. The
machine will keep the new setting until you
change it.
You can also change the volume through the
menu, by following the instructions below:
Setting the Ring Volume from the
menu
1
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Volume.
Press OK.
d Press a or b to choose Ring.
e Press d or c to choose Low, Med, High
or Off.
Press OK.
f Press Stop/Exit.
MENU
MENU
Ink Management
OK
OK
General Setup
Fax
Network
Select & Press
General Setup
General Setup
Mode Timer 2Mins
Tray Setting
Select & Press
Volume
Daylight Save
OK
On
General Setup
General Setup
Mode Timer 30Secs
Tray Setting
Select & Press
Volume
Daylight Save
OK
On
General Setup
General Setup
Mode Timer 30Secs
Tray Setting
Select & Press
Volume
Daylight Save
OK
On