11
STEP
1
STEP
2
STEP
3
For WindowsFor MAC
STEP
4
Getting started
Maintenance and
Troubleshooting
Connecting to your PC
Creating a label
Introduction
Your QL-560 comes with a paper
guide that collects strips of printed
labels that have not been cut off
from the machine.
Attach the paper guide to the front of
the QL-560 as shown in the figure.
Remove the paper guide when printing
more than 10 labels continuously and
cutting each label automatically.
Connect the AC power cord to the QL-560 and then
plug the power supply cord into a standard electrical
outlet.
• Check that the electrical outlet is 220 ~ 240 V before inserting
the plug.
• Remove the power supply cord from the electrical outlet after
you have finished using the QL-560.
• Do not pull the cord when removing it from the electrical outlet.
The wire in the cord may become damaged.
4 Installing the paper guide
Paper guide
5
Connecting to the power supply
To Next Page
Loading...
