Brother P-TOUCH QL-560 - Installing Software (Mac OS X)

15
For WindowsFor MAC
STEP
1
STEP
2
STEP
3
STEP
4
Getting started
Maintenance and
Troubleshooting
Connecting to your PC
Creating a label
Introduction
This section explains how to install the P-touch Editor 3.2, Fonts, Auto Format Templates,
and Clip Art as a whole, and to install the printer driver and set it for the printer.
The procedure for installing it varies depending on the OS version of your Macintosh
®
.
Here explains the example of Mac OS
®
X 10.3.9.
1
Start up your Mac
®
and put the CD-ROM into the CD-ROM drive.
The QL-560 screen is displayed.
If it does not start up automatically, double click the QL-560 (CD-ROM) icon.
2
Click the [Mac OS X] folder and double click [P-touch
Editor 3.2 Installer].
P-touch Editor 3.2 Installer starts up and the Introduction screen is
displayed.
3
Check the content and click [Next].
The Important Information screen is displayed.
4
Check the content and click [Next].
5
Click [Next].
You can choose which programs are
installed. Uncheck any programs that you do
not want to install.
The Choose Alias Folder screen is displayed.
2. When using Mac OS
®
X10.2~10.4.9