Brother PC-3000 - THREAD TENSION ADJUSTMENT

19
STARTING AND STOPPING SEWING
“START/STOP” button
1 Place the fabric under the presser foot, lower the presser foot,
and then press the “START/STOP” button. The sewing ma-
chine starts sewing.
* Slide the speed range control lever to adjust the sewing speed.
* Hold down the “START/STOP” button to sew at a slow speed.
2. Press the “START/STOP” button to stop the sewing machine.
Foot controller
Note
Do not allow fabric pieces and dust to collect in the foot controller.
Doing so could cause a fire or an electric shock.
1. With the sewing machine turned off, insert the foot controller
plug into its jack on the sewing machine.
1 Foot controller
2 Foot controller jack
2. Turn on the sewing machine, then slowly depress the foot con-
troller to start sewing.
* The speed set using the speed range control lever is the foot
controller’s maximum sewing speed.
3. Release the foot controller to stop the sewing machine.
* When the foot controller is being used, the “START/STOP”
button has no effect on the sewing.
Note (For U.S.A. only)
Foot controller: Model N5V
This foot controller can be used for sewing machine model PC-
3000.
2
1