46
4
1
2
6
5
3
Measure the button diameter + thickness to set the
plate.
Example:
For a button with a diameter of 1.5 cm (19/32") and
a thickness of 1 cm (25/64"), the scale should be
set at 2.5 cm (1")
1 Thickness [1 cm (25/64")]
2 Diameter [1.5 cm (19/32")]
3 Button holder plate
4 Scale
5 Diameter + thickness [2.5 cm (1")]
[0.5 cm (13/64") in one scale.]
6 0.5 cm (13/64")
3. Once sewing is completed, pull the gimp thread gently to re-
move any slack, then trim off any excess.
Buttons that do not fit into the guide plate (Odd-shaped buttons)
To Next Page
