Brother PE-DESIGN LITE User Manual

19
Tutorial
Step 9 Transferring the design to
an original card
By writing a design to a media that can be used in
your sewing machine and transferring it to your
sewing machine, you can actually sew the design.
For this example, we will transfer the design to an
original card.
Insert an original card into the USB
card writer module.
Transfer the embroidery design.
Click File, then Write to Card, then Current
Design, or click on the toolbar.
→ The following message appears.
Click OK.
→ The following message appears.
Click OK.
Quit PE-DESIGN Lite
Click File, then Exit.
b Memo:
You can also use Floppy Disks, Compact
Flash Card, and USB Media to save designs.
For the types of media that can be used with
your sewing machine, refer to your sewing
machine’s user’s manual.
a Note:
The original card is inserted correctly when
you hear it snap into place.
1
2
a Note:
Before using the original card, make sure
that the designs on the card are no longer
needed.
a Note:
• If the card writer module is not correctly
connected or powered, an error message
of “No card writer module is connected.
Please connect card writer module.” will
appear.
• If the original card is not inserted or is
defective, an error message of “No
original card is inserted. Please insert an
original card.” will appear.
3

Brother PE-DESIGN LITE Specifications

General

Brand	Brother
Model	PE-DESIGN LITE
Category	Software
Language	English