4
Before Use
Installing the Software
This section describes how to install the application software.
1. Insert the enclosed CD-ROM into the computer's CD-ROM drive.
■ For Windows® XP or 2000 users:
→ After a short while, the Choose Setup Language dialog box automatically appears.
Continue with step
4. on page 6.
a Note:
• If the installation is interrupted or not performed as described, the software will not be installed
correctly.
• Before turning on the computer, be sure that the USB card writer module is DISCONNECTED.
• In order to install the software, you must log on to the computer using an account with administrator
privileges.
b Memo:
The following installation procedure includes descriptions and dialog boxes for Windows® XP. The
procedure and dialog boxes for other operating systems may be slightly different.
b Memo:
If the installer does not automatically start up:
1) Click the Start button.
2) Click Run.
→ The Run dialog box appears.
3) Type in the full path to the installer, and then click OK to start up the installer.
For example: D:\setup.exe (where "D:" is the name of the CD-ROM drive)
To Next Page
Loading...
Need help?
General