Brother PR1055X - If the Machine Does Not Respond When a Key Is Touched

APPENDIX
189
5
If the machine does not respond when a key
is touched
If nothing happens when a key on the screen is touched (no
key can be selected or the keys are misaligned), adjust the
touch panel as described below.
a
Touch anywhere inside the touch panel, and turn the
machine off, then on again.
• Continue touching the touch panel until the screen
shown below appears.
• The “Start/Stop” button is red.
 The adjustments screen appears.
b
Use the included touch pen to touch the center of the
numbered crosses on the screen, from 1 to 13.
c
After making the necessary touch panel adjustment,
[SUCCESS] will show on the screen.
• If the buzzer sounds when cross number 13 is
touched, an error occurred during setting, and
[ERROR] appears on the screen. Touch the crosses
again, starting with the number indicated on the
screen.
d
Turn the machine off, and on again.
CAUTION
• Be sure to use the included touch pen to adjust
the touch panel. Do not use a mechanical
pencil, screwdriver or any other hard or sharp
object. Do not apply pressure to the LCD
screen display, otherwise damage to the
display may result.
Note
• If the keys still do not respond, even after the touch
panel is adjusted, or if the touch panel cannot be
adjusted, contact your nearest authorized Brother
dealer.