Brother PR1055X - Preparing the Spool Stand

20
b
Grab the grips on the thread guide assembly support
and push toward the middle.
c
After the thread guide assembly support is extended
and the thread guide assembly is raised to its highest
position, tighten the two thumb screws to secure the
thread guide assembly in place.
1 Thread guide assembly
2 Thumb screws
3 Thread guide assembly support
Preparing the spool stand
a
Loosen the thumb screw two or three turns, and then
fold out the spool stand.
Rear view
1 Thumb screw
2 Spool stand
b
After the spool stand is fully opened up, tighten the
thumb screw.
Rear view
 Secure the spool stand in the opened position.
Note
• If the thumb screws are not loosened enough, it
may not be easy to move the thread guide
assembly support. Do not apply extreme force
when moving the thread guide assembly support.
Be sure that the thumb screws are loosened well
enough before moving the part.
• Be sure to tighten each thumb screw well enough
that the thread guide assembly support is secured.