Brother ULT-2003D - I Using the Spool Net; I Vertical Spool Pin

Setting Up 1-37
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?
!
9 —
CONTENTS
Index
1
3
4
■ Using the Spool Net
If using transparent nylon thread, metallic thread, or other strong thread, place the included spool
net over the spool before using.
If the spool net is too long, fold it once to match it to the spool size before placing it over the spool.
1 Spool net
2 Thread spool
3 Spool pin
4 Spool cap
2
■ Vertical Spool Pin
Use when embroidering with metallic thread.
1. Insert the vertical spool pin into the end of the bobbin
winder shaft.
2. Install the spool felt and the thread spool in that order,
and then thread the upper thread.
1 Insert the vertical spool pin into the end of the bob-
bin winder shaft
2 Spool felt
3 Thread spool
* When setting the thread spool, set it so that the thread
winds off from the front of the spool.
* If using metallic thread, we recommend that you use a
90/14 home sewing machine needle.
Note
This method keeps the thread from twisting as it comes off
the spool pin.
1
2
3