EasyManua.ls Logo

Browning BTC-6DCLN - Fcc

Browning BTC-6DCLN
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The following options can be changed by
pressing the OK button to highlight the option,
and changing the selection using the RIGHT or
LEFT arrows. Remember to press the OK button to
save your selection. Press the DOWN button to
move to each new option to set below.
This selection returns your camera back to the
factory default selections for each setting.
By selecting DELETE ALL, all of the images on
your SD card are erased. This function also
reformats your SD card. It is a good idea to use
the DELETE ALL function and reformat your SD
card each time you install it in the camera for
use.
The software upgrade function allows you to
upgrade your software. If a software upgrade is
available for your camera, it will be posted on
our website, along with detailed instructions for
upgrading at:
www.browningtrailcameras.com/customer-service
20
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
Caution: Changes or modifications not expressly
approved by the party responsible could void the
user’s authority to operate this device.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.

Related product manuals