BB106411.book : 2237-ch4 Black 4
Chapter 4 – Data Operations
Working with Records
4–4
Brüel & Kjær2237 Controller
User Manual
4.1.2 When All Records are Full
If you attempt to store a record (either manually, or after a
preset-timed measurement) after all 40 records have been
filled, you will see the following message:
If you see this message, then you must erase some or all of
your records (see section 4.1.4) or take written records of your
measurements.
To prevent problems:
● Always check the number of records available before
starting a series of measurements.
● Always erase all records after you have downloaded and
saved them to your computer’s hard disk.
● Erase records of invalid measurements (e.g. overloads)
right away by using the Erase Last Record command (see
section 4.1.4).
Fig.4.2 The No Free Records warning
*** WARNING ****
No Free Record
to Store Current
Measurement
To Next Page
Loading...
