%
%
&" #"! !$! #
”d” :the memory will not be cleared and no tests will be carried out
during boot procedure
eth_addr_ch1, eth_addr_ch2
The parameters eth_addr_ch1 and eth_addr_ch2 are located in the write protected
range of the NVRAM. They can only be modified if the PAL device CU09Fx01 is re-
placed by CU09NP01 which is only available to the service staff.
Recommendet Parameter Setting
netaddr=0x149.236.99.99
netmask=0xffff0000
lbaut=9600
rbaut=9600
bootfile=bfs()/usr/diskless/clients/spect/root/unix
bootmode=c
console=0
cpuid=0
resetpc=xxxxxxxx
resetra=xxxxxxxx
eth_addr_ch1=0x0000ad03xx06
eth_addr_ch2=0x0000adxxxx09
version=5.40
magic=RISCPROM
model=CCU R4600
vendor=BRUKER
rootname=0
use_bootparams=1
keyswtch=0
keyboard=AT
3. 8. 3. 2. Firmware
CU09/10 needs the firmware version 97/05/01 or later. It is put into production with ver-
sion 97/06/11. This version declares CU09/10 during autonegotiation as being able to
send in half duplex mode only. This is to work around the bugs of the O2.
The monitor prints in the beginning of the boot procedure its choice
10 BASE–TX Half–Duplex
or
100 BASE–TX Half–Duplex
depending on the abilities of its link partner.
The firmware is configured as 4 byte wide and accommodated in 2 prom devices. One for
the upper and lower 2 bytes each.
" %" "! #
Name Label Function Device Type Part#
&$#
To Next Page
Loading...