%
%
&" #"! !$! #
1. Starting with CU09/10 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. 1. Special features of CU09/10 1. . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. 2. Hardware Implementation 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. 3. Software Implementation 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. 4. Problems of Point–to–Point Connection to the O2 2. . . . . . . . . .
2. Specifications 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 1. Former AQX CCU Versions 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 2. Former AQS CCU Versions 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 3. Features 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 4. Construction 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 5. Part numbers of AQX CU09 P/N H2570 7. . . . . . . . . . . . . . . . . .
2. 6. Part numbers of AQS CU10 P/N H9503 8. . . . . . . . . . . . . . . . . .
2. 7. Accessories for CU09/10 8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 8. Controls and Indicators 13. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 9. Operational Settings 14. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 9. 1. NVRAM Setting 14. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 9. 2. Configuration 15. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 9. 3. Installing DRAM 16. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. 10. Connectors and Signal Allocations 19. . . . . . . . . . . . . . . . . . . . .
2. 11. Power Requirements 22. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. Service Information 23. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 1. Operating Conditions 23. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 2. Network connection 23. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 3. Software Implementation 24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 4. Problems of Point–to–Point Connection to the O2 25. . . . . . . . . .
3. 5. Handling 25. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 5. 1. Ifconfig down/up Procedure 25. . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 5. 2. Switching the boot interface 26. . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 6. Ethernet addresses 26. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 7. Introduction Status of the AQX CU09 CCU 27. . . . . . . . . . . . . . . .
3. 7. 1. Modifications of the introduced layout 27. . . . . . . . . . . . . . . . . .
3. 7. 2. Jumper Configuration 27. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 7. 3. Configurations of the introduced layout 27. . . . . . . . . . . . . . . . .
3. 8. Introduction Status of the AQS CCU10 28. . . . . . . . . . . . . . . . . . .
3. 8. 1. Modifications of the introduced layout 28. . . . . . . . . . . . . . . . . .
3. 8. 2. Jumper Configuration 28. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 8. 3. Configurations of the introduced layout 29. . . . . . . . . . . . . . . . .
3. 8. 3. 1. NVRAM 30. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 8. 3. 2. Firmware 31. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 8. 3. 3. Serial Boot Prom 32. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3. 9. AQX CU09 CCU History of Modifications 32. . . . . . . . . . . . . . . . . .