Bryant PREFERRED T6-PRH-A User Manual

18
10. Find suitable indoor mounting location for Equipment Control Module,
either near or on equipment. See Fig. 11.
IMPORTANT NOTE: Equipment Control Module should not be mounted
to duct work or below any other controls or equipment (i.e. humidistat,
humidifier, etc.).
A07217
Fig. 11 -- Equipment Control Module on Equipment
11. Route wires through rear of Equipment Control Module using either a
clearance hole or supplied standoff. See Fig. 12.

Bryant PREFERRED T6-PRH-A Specifications

General

Brand	Bryant
Model	PREFERRED T6-PRH-A
Category	Thermostat
Language	English