If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
33
When you make a call, the
green In use light on the
base flashes.
Auto end
If auto end is set to On you
can end a call by placing the
handset back in the base If auto
end is set to Off, you’ll need to
press
to end the call.
Auto end On is the default
setting. See page 70.
Auto answer
If auto answer is set to On you
can answer a call by lifting the
handset off the base. If auto
answer is set to Off, you’ll need
to lift the handset off the base
and press
too. Auto answer
On is the default setting.
See page 70.
To switch the handset off
1. Press and hold until the handset turns off.
To switch the handset on
1. Press and hold until the handset turns on.
Make an external call
1. Press .
2. When you hear the dial tone, enter the number.
Preparatory dialling
1. Enter the number first. If you make a mistake select
Clear by pressing the Right option button to delete
the last digit.
2. Press to dial.
End a call
1. Press .
Receive a call
When you receive a call, the phone rings and the
display shows Incoming call. If you’ve got a caller
display service, the display shows the caller’s number
if it’s available or the caller’s name if it matches an
entry stored in your phonebook’s contact list.
1. Press to accept the call. Or, to accept the call in
handsfree mode, press twice.
Using the phone
Call timer
Your handset will automatically
time your outgoing and
incoming calls. The handset
shows the length of time both
during and for a few seconds
after your call.
To Next Page
Loading...
Need help?
General
