Controls and instruments
© BT Industries AB 222714-040
31
Warning codes
When an error occurs a code is displayed, during a 10 second
period, on the right-hand side of the character window (A).
If the error remains after 1 minute the warning will be reactivated
for a further 2 second period.
This process continues until the fault is rectified, however the
truck can still be driven with all functions according to the table.
The error is also indicated in the indicator window (E).
WARNING!
Ignoring error indications.
Truck safety in jeopardy.
Always contact a service technician before the truck is used
again after an error code has been displayed.
Code
No
Error type Effect on the truck
C19 The truck’s parameter values are
not OK, standard values entered.
Truck driving characteristics changed.
C20 Speed control not in neutral at start Truck cannot be driven
C26 No communication with the steer
servo when starting the truck
Truck cannot be driven
C28 Emergency switch off has been
activated.
The truck is stopped.
C29 Time for service Cause of error is shown on the display
C31 Problem with the hydraulic sensor
or the cables
The speed is maximized as if the truck
was fully loaded.
C35 Steer servo, temperature warning Cause of error is shown on the display
C41 Battery voltage too low Cause of error is shown on the display
C42 Battery voltage too high Cause of error is shown on the display
C43 High temperature in transistor
panel
Driving performance reduced
A
B
C
DE
To Next Page
Loading...
