BT OSE100 - Detailed Error Codes

Controls and instruments
© BT Industries AB 222714-040
32
Error codes
When an error occurs a code is displayed in character window
(A) and the indicator window (E) lights.
The effect of each error code on the truck is shown in the table
below.
Code
No
Error type Effect on the truck
E50 Platform switch active more than 5
minutes when truck is inactive
The truck drives in crawling speed;
2,5 km/h
E80 Steer servo error The truck drives in crawling speed;
2,5 km/h
E81 Steer servo error, too low voltage The truck drives in crawling speed;
2,5 km/h
E101 Hardware error The truck cannot be started
E104 Hardware error The truck is stopped
E106 Too high current on digital output or
field current too high
The truck is stopped
E107 Main contactor not turned on The truck is stopped
E108 Contactor welded The truck is stopped
E110 System error The truck is stopped
E113 Steer servo, unspecified error The truck is stopped
E114-
E134
Steer servo error The truck is stopped
E135 Potentiometer must be calibrated, use
parameter 36
The truck is stopped
E136 Potentiometer error The truck is stopped
E137 Steer servo, check sum error The truck is stopped
E138 Steer servo, no communication The truck is stopped
E139 Communication error The truck is stopped
E140 Check sum error The truck is stopped
E141 Faulty software The truck is stopped
E150 Communication fault The truck is stopped
E151 Communication fault The truck is stopped
A
B
C
DE