BT OSE100 - Lubrication Chart; Oil and Grease Specification

Maintenance
© BT Industries AB 222714-040
55
Lubrication chart
L= Lubrication C = Check O = Oil change
4 = Replace the oil the first time prior to 500 hours and then every 3000 hours/36 months.
5 = Replace the oil and clean the filter the first time prior to 500 hours and then every
1,000 hours/12 months.
Oil and grease specification
Pos no Service point Interval/Running hours Lubricant
500 h 1000 h 3000 h
2550 Drive transmission O
4
C O C
2550 Gear ring L E
6100 Hydraulic system O
5
O B
7100 Mast rollers/profiles L D
7160 Initial lift mast/chains L A
Lubricant Specification Application area
> - 15°C < - 15°C
A Grease BT 055 73100 (tin)
BT 055 73040 (spray)
BT 055 73100 (tin)
BT 055 73040 (spray)
Initial lift mast/chains
B Hydraulic oil ISO-L-HM32 ISO-VG32 Hydraulic system
C Transmission
oil
Hypoid oil
SAE 80W/90
Hypoid oil
SAE 75W
Drive transmission
D Grease See table below See table below Mast rollers/profiles
E Grease Grafloscon
A-G1 (Klüber)
Grafloscon
A-G1 (Klüber)
Gear ring
Ambient temperature Viscosity class Recommended products
(Similar products from other manufactur-
ers may be used)
> - 40°C
< - 30°C
VG 15 Klüberoil 4UH 1-15, Klüber Lubrication
> - 30°C
< + 5°C
VG 68 Klüberoil 4UH 1-68N, Klüber Lubrication
Anticorit LBO 160 TT, Fuchs DEA
> + 5°C
< +45°C
VG 150 Klüberoil 4UH 1-150N, Klüber Lubrication
Anticorit LBO 160, Fuchs DEA
Rexoil, Rexnord Kette
>+ 45°C
<+ 80°C
VG 220 Klüberoil 4UH 1-220N, Klüber Lubrication