26
Stopwatch timer
In standby mode, press and hold the key to display
the stopwatch. To start counting, press the MENU key.
Press the MENU key again to restart counting.
To exit the function, stop the counting rst, then press
the EXIT key.
Advanced Features
Scanner
The radio features a built-in scanner for VHF and UHF bands. In
Frequency (VFO) mode, it scans in steps according to your set frequency
step. In Channel (MR) mode, it scans your channels.
To enable the scanner, press and hold the key for about two seconds.
You can change the scanning direction with the
or keys. Press and
hold the key again to exit scanning mode.
Frequency Range Scanning
In frequency mode, you can set the frequency sweep range precisely by
inputting the start and end values of the sweep frequency through the
keyboard. For VFO frequency range settings, set Menu > Scan > Freq Range.
• Enter 144146 to scan in the range of 144.000-146.000 MHz
• Enter 430440 to scan in the range of 430.000-440.000 MHz
Scan modes
The scanner can operate in three modes: Time, Carrier, or Search.
Time Operation (TO)
The scanner stops when it detects a signal and resumes scanning
after a preset timeout.
Carrier Operation (CO)
The scanner stops when it detects a signal and resumes scanning
after the signal disappears.
To Next Page
Loading...
