VISIT BAOFENGTECH.COM FOR DOWNLOADS AND HELP 35
VFO Repeaters Programming
The following instructions assume you know the transmit and receive
frequencies your repeater uses and that you are authorized to use it.
1. Press the V/M key to set the transceiver to VFO mode. The VFO
icon will be displayed on the right.
2. Use the numeric keypad to enter the repeater's output (your
receive) frequency.
3. Press [5] [1][2] to set the Offset frequency.
4. Use the numeric keypad to enter the specified frequency Offset.
5. Press the key to confirm and save.
6. Press [5] [1][3] to set the Offset direction.
7. Use the
or keys to select plus (positive) or minus (negative) Offset.
8. Press the key to confirm and save.
9. Optional steps:
• Save to memory. Refer to the section titled "Manual
Programming" for details.
• Set up CTCSS. Refer to the section titled "CTCSS" for details.
10. Press the key to exit the menu. If everything went well, you should
be able to make a test call through the repeater.
If you experience problems connecting to the repeater, check your
settings and repeat the procedure. If you are still unable to make a
connection, contact the person in charge of the radio system with your
employer or your local amateur radio club.
GPS function
The GPS function includes optional features that require hardware
support. The position system utilizes a DTMF calling application.
For setting call codes, call names, and local IDs, refer to the section
"Signaling Calls."
To Next Page
Loading...
