VISIT BAOFENGTECH.COM FOR DOWNLOADS AND HELP 27
Search Operation (SE)
The scanner stops when it detects a signal. To resume scanning,
press and hold the key again.
For scan mode settings, set Menu > Scan > Scan Mode.
Scan Sub-Code
To search for a CTCSS or DCS code (An active receiving signal must be
present to work):
CTCSS Code
1. In VFO mode, enter a known frequency, such as 144.525.
2. Press the key to enter Menu > Scan > Scan SubCode.
3. Select CTCSS using the
or keys.
4. Press the key to enter the CTCSS code scanning mode. The
scanner will stop on a valid CTCSS code, and the speaker will
turn on.
5. Press the key to store the scanned CTCSS code and exit the
scan. The icon will be displayed on the top line of the screen.
Press and hold the PTT key to make a callback.
DCS Code
1. In VFO mode, enter a known frequency, such as 144.525.
2. Press the key to enter Menu > Scan > Scan Sub-Code.
3. Select DCS using the
or keys.
4. Press the key to enter the DCS code scanning mode. The
scanner will stop on a valid DCS code, and the speaker will turn on.
5. Press the
key to store the scanned DCS code and exit the scan.
The icon will be displayed on the top line of the screen. Press
and hold the PTT key to make a callback.
To Next Page
Loading...
