28
Sub-Code scan storage
In MR or VFO mode, the scanned CTCSS/DCS code can be stored as
only TX, only RX, or both TX and RX codes, replacing the current channel
or frequency mode's settings.
To save the settings of the scanned CTCSS/DCS code:
1. Press the key to enter Menu > Scan > Scan Memory.
2. Enter the Scan Memory setting and use the
or keys to select:
All: Stores the scanned code as both RX and TX codes.
Receive: Stores the scanned code as the RX code only.
Transmit: Stores the scanned code as the TX code only.
3. Press the key to save the settings and return to the previous menu.
This feature is used with the Scan Sub-code function detailed above.
Dual Watch / Single Watch
In certain situations, being able to monitor two channels at once can be
very useful. This can be achieved in two ways:
Dual Watch
One receiver rapidly checks between two frequencies.
Dual Receive (Dual VFO)
A radio equipped with two receivers monitors two frequencies
simultaneously.
Your radio supports Dual Watch functionality with a single receiver,
allowing you to lock the transmit frequency to one of the two monitored
channels. To enable or disable Dual Watch mode:
1. Press the
key to enter the main menu.
2. Enter [3] on the numeric keypad to go to Radio Settings.
3. Press the key to confirm and enter [14] on the numeric keypad
to access Dual Watch.
4. Press the key to select.
To Next Page
Loading...
