VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Making!a!call!
Press and hold the PTT button on the side of the handheld mic to transmit. While transmitting, speak
approximately 3-5cm (1-2 inches) from the microphone. When you release the PTT, your transceiver will
go back to it receive mode.
Channel!selection!
There are two modes of operation: Frequency (VFO) mode, and Channel or Memory (MR) mode.
For everyday use, Channel (MR) mode is going to be a whole lot more practical than Frequency (VFO)
mode. However, Frequency (VFO) mode is very handy for experimentation out in the field. Frequency
(VFO) mode is also used for programming scanning channels into memory. For details on how to program
your transceiver see Chapter 4.
Frequency (VFO) mode
In Frequency (VFO) mode you can navigate up and down the band by using the and keys (or
rotating the selector knob). Each press (or rotation click) will increment or decrement your frequency
according to the frequency step you've set your transceiver to (Menu Item 1: Step)
To Next Page
Loading...
