VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Remote Kill
First set the DTMF Remote Kill Tone and Master Control ID in Software: When your radio receives the
DTMF Remote Kill Tone Sequence (Set by software) (Requires Menu 18 and 19 to accept DTMF signaling)
it will command the radio to disable transmitting and receiving. The Master ID station must first identify
and send the PTTID (set in software as “Master ID”) – once the Master Station identifies itself, the radio
is set to receive command tones, if the Monitor Remote Kill tone is received - the radio will no longer be
able to transmit or receive. Both the master ID station and remote stun signal must be set up in
software.
Remote Revive
First set the DTMF Remote Revive Tone and Master Control ID in Software: When your radio receives
the DTMF Remote Revive Tone Sequence (Set by software) (Requires Menu 18 and 19 to accept DTMF
signaling) it will reactivate the radio after it has been remotely stunned or killed. The Master ID station
must first identify and send the PTTID (set in software as “Master ID”) – once the Master Station
identifies itself, the radio is set to receive command tones, if the Monitor Remote Kill tone is received -
the radio will revived from a stun/kill command. Both the master ID station and remote stun signal must
be set up in software.
To Next Page
Loading...
