VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
After that, use the menu system to configure the finer details of the channel you're wanting to program to
memory, such as bandwidth, CTCSS or DCS and more.
Adding Scanning Channels
The following steps assume that you're in Frequency (VFO) mode and that you've entered the desired
frequency to store to memory.
1. Press the key to enter the menu.
2. Enter 46 on the numerical keypad to get to MEM-CH.
3. Press to select.
4. Use the and keys to select an empty memory channel or enter it directly on the
numerical keypad.
5. Press the key to confirm.
6. Press the key to exit the menu.
Switch your radio to Memory (MR) mode by turning the radio OFF, and then Press and Hold button
while powering on to test your new channel. If you would like to name your channel you will need to do
that from a computer. More on that in the section called “Computer programming”.
!
To Next Page
Loading...
