VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
You can also input frequencies directly on your numeric keypad with kilohertz accuracy. However, the
radio will floor to the nearest frequency that corresponds to your frequency step, in other words, when
you input frequencies with greater than 1kHz resolution (such as 145.6875 MHz in the example below),
always round your input up.
Channel (MR) mode
The use of Channel (MR) mode is dependent on actually having programmed in some channels to use.
The GMRS-50X1 is hard loaded with the 30 GMRS channels (see the GMRS Frequency Chart, Channel
Guide in Chapter 2 for Channels and Transmitting restrictions). You can program additional analog
scanning channels into memory channels 000 and 031-255.
You can use the and keys to navigate between channels (or Rotate the Selector Knob)
!
Monitor!Both!VFO!&!MR!Modes!
You can toggle from VFO and MR (Memory Recall) mode by either pressing the V/M button on the front
of your radio, or you can toggle modes from the Handheld Mic by a long press of the ‘Menu’ button.
To Next Page
Loading...
