VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
The BTECH GMRS-50X1 has a full implementation of DTMF, including the A, B, C and D codes. The
numerical keys, as well as the , and , keys correspond to the matching DTMF codes as you would
expect. The A, B, C and D codes are located in the , , and keys respectively (†).
Manually TX DTMF Tones: To manually send DTMF codes, press the key(s) while holding down the PTT
key.
Automatically TX DTMF Tones:
Save it to Memory and Transmit: You can also program a DTMF tone to the saved calling list (requires
the PC software) to the one of the 15 Memory call banks in the radio. To transmit select the Pre-set
DTMF saved setting on Menu 22 and then press the call key to send the saved DTMF TX tone.
Remote Stun
First set the DTMF Remote Stun Tone and Master Control ID in Software: When your radio receives the
DTMF Remote Stun Tone Sequence (Set by software) (Requires Menu 18 and 19 to accept DTMF
signaling) it will command the radio to disable transmitting abilities. The Master ID station must first
identify and send the PTTID (set in software as “Master ID”) – once the Master Station identifies itself,
the radio is set to receive command tones, if the Monitor Remote Stun tone is received - the radio will
no longer be able to transmit. Both the master ID station and remote stun signal must be set up in
software.
To Next Page
Loading...
