VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
DCS!
DCS is set with menus 10 R-DCS and 12 T-DCS.
For a complete list of available DCS codes, see Table C.1, “DCS Codes” in Appendix C,
Technical specifications.
Procedure 8.2. DCS setup how-to
1. Press the key to enter the menu.
2. Enter on the numeric keypad to get to receiver DCS.
3. Press to select.
4. Scroll to the desired DCS code on the numeric keypad.
5. Press to confirm and save.
6. Enter on the numeric keypad to go to transmitter DCS.
7. Press to select.
8. Scroll to the desired DCS code on the numeric keypad. Make sure it's the same code as that you
entered for receiver DCS.
9. Press to confirm and save.
10. Press to exit the menu system.
To turn DCS off, follow the same procedure but set it to off with the key instead of selecting a DCS
code.
For more information see the section called “10 R-DCS - Receiver DCS” and the section called “12 T-DCS -
Transmitter DCS” in Appendix B, Menu definitions.
To Next Page
Loading...
