What does it mean if Infusion Catheter and Ultrasonic Core are not compatible in BTG Control Systems?
If the BTG Control Systems indicates that the Infusion Catheter and Ultrasonic Core are not compatible, it means there's a mismatch in either catheter zone length, ultrasound zone length, or working length. Notify the physician about this issue.
How to resolve incompatibility of CIC error on BTG EKOS Control Systems?
If the BTG Control Systems displays a message about incompatibility of CIC, it means the Connector Interface Cable is not compatible with the Infusion Catheter, Ultrasonic Core, or both. Replace the Connector Interface Cable with one that is compatible with both the Infusion Catheter and Ultrasonic Core.
Why does BTG EKOS say to replace the Connector Interface Cable?
If you are prompted to replace the Connector Interface Cable on your BTG Control Systems, this indicates that the cable is defective. Replace the Connector Interface Cable.
Information on the Control Unit, cables, and its functions for ultrasound therapy.
Crucial safety statements for operating the Control Unit to prevent injury or damage.
Details AC power use, battery charging, and status indicators.
Explains battery gauge, low battery, critically low battery, and error notifications.
Guides through preparing the system and initiating ultrasound therapy.
Identifies system and channel errors, their causes, and resolution steps.
General| Manufacturer | BTG |
|---|---|
| Model | EKOS |
| Input Voltage | 24 VDC |
| Power Consumption | 10 W |
| Communication Protocol | Modbus RTU |
| Protection Class | IP20 |
| Category | Control Systems |
| Operating Temperature | 0 to 50°C |
To Next Page