Buchi V-100 - Connecting Interface Unit to Vacuum Pump V-100

BÜCHI Labortechnik AG Installation | 5
Operation Manual Vacuum Pump V-100 29/52
Fitting the interface unit
1
1
2
3
Fig.16: Fitting the Interface I-100
1 Interface I-100 3 T-screw
2 Holder
u Fit the interface unit (1) onto the holder (2).
u Tighten the T-screw (3) on the back of the interface unit by turning it clockwise.
5.9.2 Connecting interface unit to Vacuum Pump V-100
The V-100 is connected to the Interface I-100 by means of a communication cable
(mini-DIN socket on rear of vacuum pump – see illustration in Chapter5.8 "Electrical
connections", page27) and a tubing (from top outlet of Woulff bottle – see illustration
in Chapter5.5 "Connecting a Woulff bottle", page23). For more information on con-
necting the tubing and communication cable, refer to the section "Commissioning" in
the operating instructions for the Interface I-100.