Buchi V-100 - Connecting Secondary Condenser

5 | Installation BÜCHI Labortechnik AG
24/52 Operation Manual Vacuum Pump V-100
5.6 Connecting a secondary condenser
1
1
4
1
2
1
3
Fig.11: Connecting secondary condenser to V-100
1 Secondary condenser 3 Holder
2 Pump outlet 4 Screw
NOTE
Connecting a secondary condenser is advised particularly in cases where the pump
outlet cannot be connected to a fume hood or the solvent concentration in the vapor
is too high. The secondary condenser reduces the amount of vapor emitted.
The secondary condenser is connected directly to the pump outlet (2) on the rear of
the V-100.
Fitting holder for secondary condenser
Tools required: Torx key (fitted in pump top cover – see Chapter3.2.3 "Internal view",
page12).
u Position the holder (3) below the pump outlet (2) and fix to the pump housing by
means of two screws (4).