Additional programming options
8
Logamatic 4321/4322 - Technical specifications are subject to change without prior notice.
61
Only after all three details (day/time/temperature) have been set for the new set
point will it be automatically saved under "custom program" and the heating
zone number (here: "2"). The saving process is not shown on the display. The
display shows the blank mask "new set point" for the next set point.
z Enter the second set point (Monday – Friday, 9:00 pm (21:00 h),
63 °F (17 °C)).
z Enter the third set point (Saturday – Sunday, 9:30 am (09:30 h),
70 °F (21 °C)).
z Enter the fourth set point (Saturday – Sunday, 11:30 pm (23:30 h),
63 °F (17 °C)).
To enter the second to fourth set points, you only need to repeat the previous
steps.
Only after all set points have been correctly entered, press "Back" to return to
the permanent display.
Your heating program will now operate according to your "custom program". You
can call up your new "custom program" by pressing "PROG" and turning the dial.
new set point
--------------
----
at ---
To Next Page
Loading...
