Principles of operation
Logamatic EMS RC35 programming unit - Subject to technical modifications
20
4
4.9 Viewing information (Info menu)
You can use the INFO menu to view set and recorded values. The exact information available
depends on the components installed in your heating system.
DHW message in the INFO menu
DHW is switched off at the boiler. This message means that rotary selector on the boiler
programming unit is set to “0”. To enable DHW heating to be adjusted via the RC35, turn rotary
selector to “AUT”
1)
.
Operation Result
1. Open the flap (by pulling the recessed grip on the left).
2. Press to open the INFO menu.
The message on the right is displayed for five seconds. It then
moves on automatically.
-or-
Turn rotary selector to move immediately to the next
display.
3. Turn rotary selector to view further information.
4. To exit the info menu: press or close the flap.
The standard display reappears.
1) Setting subject to the boiler installed.
The operating mode buttons do not do anything in the INFO menu.
10:20h
21.5°C
02.12.2005
Fr
By turning the dial
you can obtain plant
information.
To Next Page
Loading...
Need help?
General
