Electronics
SnackFix
TM
2018-05 V1.8 7
2 Electronics
The electrical system has been installed to supplied the wiring diagram.
The Operator can see all the relevant process data on the operating panel.
2.1 Layout data
Protection type motor: IP 54 / IP 56
Connection: 380V – 480 V three phase current, 50 cy / 60 cy
Speed regulation: frequency converter/Siemens G120C
Overload protection: Thermo contact
2.2 Perimeter
Memory programmable control, freely programmable for process control and
observation of the machine, type Siemens CPU 1215C.
Drive control via frequency converter Siemens G120C.
Electric cabinet in stainless steel with built in main switch in the cabinet door.
The machine is operated via an Operator Panel, built in with a separate housing
on an arm. An emergency STOP and a RESET are additionally on the operator
panel. The operator panel KTP400 Basic is equipped with the visualisation
software TIA Portal. This is used for the operation and the visualisation of the
machine.
Complete wiring between the machine, control cabinet and operator panel.
Hardware documentation.
2.3 Start-up
Before the test run of the machine, which is carried out without product, it has to
be checked that the working areas of the machine are free from tramp parts.
To Next Page
Loading...
