Production Start / Stop
SnackFix
TM
2018-05 V1.8 39
8.3 Select the Operating Mode MS
The operating modes of the cutter can only be changed when the knife is at a
standstill.
After changing the operating mode from continuous to start / stop, the
knife can only start when the initiator is no longer dampened. If this is the
case, the “cutter on” button must be pressed for approx. 1 sec
The following operating modes are available:
• Continuous
Through actuating the function key "Cutter ON" the cutter moves contin-
uously. The speed of the cutter depends on the speed of the feeding belt
and the set cutting length.
• Start/Stop
Through actuating the function key "Cutter ON" the cutter is switched on.
When the set cutting length has been reached the cutter speed is in-
creased to its maximum speed. After the cut the cutter remains in the
upper position and waits until the next cutting length has been reached.
• Adjust
In the Adjust mode „Manual” the knife travel axis can be jogged forward
with the touch button and. The knife travel axis turns as long as the but-
ton is actuated
To Next Page
Loading...
