Bunn IMIX - Programming Calibration & Diagnostics

23
SERVICE (cont.)
PROGRAMMING - CALIBRATION & DIAGNOSTICS
42032 060109
DISABLE MESSAGES ?
NO EXIT YES
TANK TEMP XXX°
READY TEMP XXX°
(-) EXIT (+)
STRENGTH ADJ. ?
(-) EXIT (+)
EXIT YES
ENTER PASSWORD
(-) XXXX (+)
CALIBRATION ?
EXIT YES
LOCKS/DISABLES ?
EXIT YES
AUDIBLE ALARM ?
NO EXIT YES
ENABLE ADS ?
NO EXIT YES
ENTER ASSET # ?
EXIT YES
ENABLE SERVICE ?
NO EXIT YES
ENABLE EnergySavr ?
DIAGNOSTICS ?
EXIT YES
DISPLAY USAGE ?
EXIT YES
FACTORY DEFAULTS
NO YES
NO EXIT YES
To
Calibration
FINISHED, returns
to main screen
Adjust tank
temperature
Adjust minimum
tank ready
temperature for
lockout
To
Diagnostics
XX° CAL XX°
(-) Tank Temp (+)
SELECT UNITS
ENG EXIT METRIC
Calibration
235 REFILL 155
(-) EXIT (+)
CAL WATER 1 ?
PRESS DISPENSE
ENTER VOLUME 1
(-) XX.X oz (+)
CAL POWDER 1 ?
PRESS DISPENSE
ENTER WEIGHT 1
(-) XX.X gm (+)
Auger Delay
(-) .XX sec (+)
CAL HOPPER 1 ?
NO YES
Goes to next station.
Continues after last station.
TEST SWITCHES ?
Use Switch To Test
TEST HEATER ?
EXIT YES
TEST REFILL ?
EXIT YES
TEST HOT WATER ?
EXIT YES
TEST AUGERS ?
DISPENSE TO TEST
TEST DISPENSE HEAD?
DISPENSE TO TEST
Diagnostics
Goes to next station.
Continues after last station.
Returns to A
Returns to B
(A)
(B)