27
DISPENSE SWITCHES
SERVICE (cont.)
P3243
FIG.23 DISPENSE SWITCHES
Location:
The dispense buttons are located on the lower
outside of the dispenser door and actuate switches on
the dispense switch board located on the inside of the
door.
Test Procedure:
Enter Programming and Test Switches.
Removal and Replacement:
1. Disconnect the dispenser from the power source.
2. Open the dispenser door.
3. Remove the four #8-32 screws securing the lower
door panel and remove the panel.
4. Disconnect the five pin harness from the switch
board.
5. Remove the four #6 screws securing the switch
board to the door frame and discard the board.
6. Other parts of the switch assembly may be removed
if necessary.
7. Install the new switch board using the four #6
screws.
8. Connect the five pin harness to the switch board.
9. Install the lower door panel using the four #8-32
screws.
P1449
FIG. 24 DISPENSE SWITCH BOARD
PUSH BUTTON
PORTION CONTROL
42032 060109
To Next Page
Loading...
