Bunn ULTRA - UltraPAF Error Messages

Ultra Training Manual
40
Ultra PAF Error Messages
Door Lamp Fault
On
Normal operation the Powder Autoll is ready to
dispense.
Flashes On/Off at 50% duty cycle Low product level in Powder Autoll hopper.
Two ashes about every 2 seconds Ultra/Powder Autoll probe circuit open.
Three ashes about every 2 seconds Powder Autoll hopper not in place.
Four ashes about every 2 seconds Ultra rell exceeded 5 minutes.
Off Door not closed.
Ultra 1 Triac Map
1. TH1 = Auger
2. TH2 = Compressor Relay
3. TH3 = Refrigeration
4. TH4 = Rell Valve (not currently offered)
5. Q4 = Fan