LOWLANDER HD MK2 & WIDEBODY MANURE SPREADER – INSTRUCTION & SPARES MANUAL
Page 104
6.4.5.2.5 ADJUSTING THE FULL-LOCK ANGLE (DEPENDING ON THE MODEL)
Adjust the full-lock stop screws to limit the axle full-lock angle when fitting wide tyres.
Check the full-lock angle regularly by turning fully to the right and to the left and checking that the tyres do not touch the trailer or
suspension as this might wear or damage the tyres.
Adjust the full-lock stop screws, if appropriate.
Tighten the lock nuts.
6.4.5.3 DRIVEN STEERING AXLES
To align a steered axle, bleed the hydraulic circuit or carry out any other maintenance on the hydraulic system, see the vehicle
manufacturer's manual.
NOTE: Before carrying out any work on hydraulic or pneumatic systems, take all necessary precautions to ensure that the
hydraulic fluid or air is not under pressure.
To Next Page