11. PACKAGING, TRANSPORT
NOTE
Damage due to transport
Transport may damage an insufficiently protected sensor.
▶ Transport the sensor in shock-resistant packaging and away
from humidity and dirt.
▶ Do not expose the sensor to temperatures that may exceed the
admissible storage temperature range.
▶ Protect the electrical interfaces using protective plugs.
12. STORAGE
NOTE
Poor storage can damage the sensor
▶ Store the sensor in a dry place away from dust.
▶ Storage temperature for a "trace" chlorine sensor (order code
565164): 0...+40 °C.
▶ Storage temperature for a chlorine sensor (order code
568524
1)
or 568523
2)
): 0...+45 °C.
▶ Do not store nor reuse membrane caps which have been in
operation.
▶ Respect the storage temperature indicated on the electrolyte
bottle.
1) or other chlorine sensor for operation at constant pH
2) or other chlorine sensor having a reduced pH-dependency
To store the sensor:
1. Unscrew the membrane cap from the shaft.
2. Rinse the reference electrode in clean water: do not touch nor
rub the electrodes. Let it dry in a place free of dust.
3. Rinse the membrane cap in clean water and let it dry in a place
free of dust on an absorbent paper.
4. For the "trace" chlorine sensor with order code 565164, remove
the internal holder from the membrane cap, rinse it in clean
water and let it dry separately on an absorbent paper.
5. Screw but do not tightly fasten the dry membrane cap onto the
shaft to protect the electrodes.
6. When using the sensor after storage, clean the electrode tip
with the special abrasive paper and use a new membrane cap
(see chap. 9.3.2 and chap. 9.3.3).
13. DISPOSAL OF THE SENSOR
→ Dispose of the sensor and its packaging in an environmentally-
friendly way.
NOTE
Damage to the environment caused by parts contaminated by
the fluid.
▶ Comply with the national and/or local regulations which concern
the area of waste disposal.
32
Packaging, transport
Type 8232
english
To Next Page
Loading...
