2. INTENDED USE
Use of the sensor that does not comply with the instructions
could present risks to people, nearby installations and the
environment.
The chlorine sensor type 8232 is used to measure the free
chlorine concentration in water.
The "trace" chlorine sensor type 8232 is used to measure chlorine
concentration in water at very low concentrations or to monitor the
absence of chlorine.
▶ Use the sensor only in combination with foreign devices or for-
eign components recommended or approved by Bürkert.
▶ The sensor must be used in compliance with the characteristics
and commissioning and use conditions specified in the contrac-
tual documents and in these Operating Instructions.
▶ Requirements for the safe and proper operation of the sensor
are proper transport, storage and installation, as well as careful
operation and maintenance.
▶ Only use the sensor as intended.
3. BASIC SAFETY INFORMATION
The safety information does not take into account:
• any contingencies or occurrences that may arise during instal-
lation, use and maintenance of the devices.
• the local safety regulations for which the operating company
is responsible including the staff in charge of installation and
maintenance.
Risk of injury due to electrical voltage
Risk of injury due to high pressure in the installation
Risk of injury due to the nature of the fluid
Risk of injury due to the nature of the electrolyte
Various dangerous situations
To avoid injury take care:
▶ to prevent any unintentional power supply switch-on.
▶ to ensure that installation and maintenance work are carried out
by qualified, authorised personnel in possession of the appropri-
ate tools.
▶ to guarantee a set or controlled restarting of the process, after a
power supply interruption.
6
Intended use
Type 8232
english
To Next Page
Loading...
