BURNiT Pell 25 - Instructions to Installation User

5
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
• Do not install the burner in sleeping
premises.
• Do not connect the burner to any other
air-intake systems .
• The burner must be connected to the
boiler as a heang device
• Improper installaon may cause re or
injury. Contact your local construcon
supervisory body in case you need
prior approval for installaon of this
product.
• Mandatory is the installaon of smoke
detectors in the room where the
burner is installed.
• Pellet burner is NOT designed for
installaon in motorhomes, caravans
etc.
1.2.2.Instruconstoinstallaonuser
$
DANGER of intoxication or
explosion
Toxic gases may be discharged
when burning waste, plastics,
liquids.
- Use only the fuels indicated in
this manual.
- In case of danger of explosion,
ignition or discharge of exhaust
gases in the room, stop the
pellet burner from operation.

CAUTION! Danger of injury
/ damage of system due to
incompetentoperation.
- The pellet burner must be
serviced only by persons familiar
with the operation manual.
- As a user, you are only allowed
to start the pellet burner up,
adjust the temperature of the
burner, shut the burner down
and clean it.
- Unattended children must not
be allowed access to premises
with running pellet burner
inside..

It is mandatory to assure a
backup power generator of
corresponding rated power!
(see 12.3)
Safetyrulesforuseroperaon:
- Operate the pellet burner on
recommended fuel only, and to that
end you must regularly inspect the
boiler room.
- Do not use ammable liquids for
ignion or increase of burner output.
- Collect ash in lid-covered reproof
containers.
- Clean the burner surface using non-
ammable agents only.
- Do not place ammable objects onto
the burner housing and heang boiler
cabinet or in their proximity. (see
diagram 1 for the minimum clearances)
- Do not store ammable materials in the
boiler room.
- Boilers, chimneys and other
connecons of mounted burner must
meet standards for re and emergency
safety of the country.
- It is mandatory to strictly observe
instrucons for connecng the burner
to power network as well as to all
peripherals.
- Structural changes to burner by user
can cause damage to equipment or
injury.
- Do not allow contact transmission of
electrical wire or touch any part of the
boiler, where the surface temperature
can exceed 70 °C.
- Dismount the burner when the boiler
are heang alternave (mainly) of fuel
- wood, wood briquees, coal or other
fuel.
- This manual should be kept throughout
the lifeme of the burner.