BURNiT Pell 25 - 4 Transportation of the Pellet Burner; 5 Delivery of the Pellet Burner

TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
10
i
When purchasing pellets, ask
for conformity declaration
and certificate issued by an
accredited laboratory and
make sure the fuel meets the
requirements indicated in the
manual. If you purchase large
amount of pellets (bulk supply
for the entire heating season
for example), ask your supplier
to provde accurate and true
information about the storage
conditions.
We recommend to use pellet with size of
6 - 8mm. Density 600 - 750kg/m
3
heang
value 4.7 - 5.5 kWh/kg. Ash content – less
than 1% and moisture content up to 8%,
EN ISO 17225-2:2014.
The opmal density of the pellets which
guarantees their quality is 605-700 kg per
cubic meter.
Pellet moisture content must not exceed
10%. Make sure you store your fuel in a
dry and well-venlated place.
The opmal pellet ash content is ≤ 1%.
This also provides for less frequent
cleaning intervals for the burner.
The table below contains the parameters
which we recommend that you take into
consideraon when choosing fuel for
your „Pell” burner.
4. TRANSPORTATION OF THE PELLET
BURNER
When loading, transporng and
unloading of the device appropriate
safety equipment must be used in
accordance with Direcve 2006/42/SE.
Product must be in original packaging
following the instrucons on the label -
to be protected from adverse weather
condions (snow, rain and dust) from
the shocks, and other acvies likely to
cause damage. In case of malfuncon of
the fan or the motor drive (noise, fricon)
or failure of high-tech elements such as
broken LCD screen, contact your nearest
authorized service center for repairs and
maintenance.
- Dimensions of the packaging of the
burner: 450х350х750 mm
- Dimensions of the packaging of the
auger: 260х120х1700 mm
5. DELIVERY OF THE PELLET BURNER
• Inspect the integrity of the packaging
upon delivery.
• Check whether all components
have been delivered to you. Burner
consignment package includes
(diagram 3):
1) Pellet Burner Pell with built-up Control
unit
2) Feeding chute
3) Fire irons
4) Auger
5) Technical passport. Installaon and
operaon manual
6) Service booklet and Warranty card
If any of the above items are missing,
contact your supplier.