BUSCH DUPLEX - EU Declaration of Conformity

17 | EU Declaration of conformity
0870S03226_VRD 2072-3108_-0000_IM_en
41 /
44
17 EU Declaration of conformity
This EU declaration of conformity and the CE marking on the name plate apply to the machine in the scope of the
delivery by Busch. The manufacturer is solely responsible for issuing this declaration of conformity.
If the machine is integrated into a higher-level machine system, the manufacturer of this system (if applicable, the
company operating the system) must issue a declaration of conformity for the higher-level machine or system and
affix the CE marking.
Manufacturer Dr. Ing. K Busch GmbH
Schauinslandstr. 1
DE-79689 Maulburg
Declaration for vacuum system(s) of type: VRD 2072, VRD 3108
with serial number from 2021 … to 2022 …
was/were produced according to the following EU standards:
− "Machinery directive" 2006/42/EG
− "Directive on electromagnetic compatibility" 2014/30/EU
− “RoHS2 Directive” 2011/65/EU, 2017/2102, Restriction of the use of certain hazardous substances in electri-
cal and electronic devices
and according to the corresponding standards.
Standard Name of the standard
EN ISO 12100:2010
Safety of machinery – General principles for design, risk assessment and
risk reduction
EN ISO 13857:2019
Safety of machinery – Safety distances to prevent hazard zones being
reached by upper and lower limbs
EN 1012-1:2010
EN 1012-2:1996+A1:2009
Compressors and vacuum pumps – Safety requirements – Parts 1 and 2
EN ISO 2151:2008
Acoustics – Noise test code for compressors and vacuum pumps –
Engineering method (grade 2)
EN 60204-1:2018
Safety of machinery – Electrical equipment of machines – Part 1: Gen-
eral requirements
EN IEC 61000-6-2:2019
Electromagnetic compatibility (EMC) – Generic standards – Immunity
standard for industrial environments
EN 61000-6-
4:2007+A1:2011
Electromagnetic compatibility (EMC) – Generic standards – Emission
standard for industrial environments
EN ISO 13849-1:2015
Safety of machinery – Safety-related parts of control systems – Part 1:
General principles for design
Person authorized to compile the technical data: Klaus Digeser
Dr. Ing K. Busch GmbH
Schauinslandstr. 1
DE-79689 Maulburg
Maulburg, 02/10/2021
Dr.-Ing Karl Busch, general manager