Butler LIBRAK380.3DTEC - Fixtures Contained in the Packing

INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 13 of 62
1300A004
999072
129571492
GAR111
GAR101
GAR108
A
Fig. 6
THE GRIP-RING (FIG. 6 REF. A)
MUST BE MOUNTED WITH THE
TEETH OR DISCHARGE SIDE
TOWARDS THE RING-NUT OR
SLEEVE (SEE FIG. 6).
1297-M021-1_B
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
• Execute 4 holes with 10 mm diameter on the floor
by the holes on the bottom floor;
• insert the small blocks (excluded from supply) into
the holes;
• fix the machine to the ground with 4 M8x80 mm
screws (excluded from supply) (Fig. 5 ref. 1) (or
with 4 8x80 mm stud bolts (excluded from supply)).
Tighten the screws with an approximate tightening
torque of 70 Nm.
9.2 Fixtures contained in the packing
The packing case contains also the fixtures box.
Check that all the parts listed below are there (see
Fig. 6).
For LIBRAK380.3DTEC - LIBRAK430.3DTEC mod-
els
Code Description N.
GAR101 Rapid ring nut + pusher ring 1
GAR111 Cones + protection cup 1
129571492 Manual external data gauge 1
1300A004 Weight pliers 1
999072 Carriages counterweight 1
For LIBRAK380P.3DTEC - LIBRAK430P.3DTEC
models
Code Description N.
GAR108 Rapid ring nut + pusher ring 1
GAR111 Cones + protection cup 1
129571492 Manual external data gauge 1
1300A004 Weight pliers 1
999072 Carriages counterweight 1