GB
Page 34 of 62
INSTRUCTION, USE AND
MAINTENANCE MANUAL
14.6.2 Static-1
The STATIC 1 function is a procedure that offsets wheel
vibrations using a single weight with clip on a single
plane positioned exactly at 12 o’ clock.
Enter the measurements (see Par. 14.2.1) and proceed
as described in Par. 14.5 "Dynamic balancing" (only for
wheel inner side).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
14.6.3 Static-2
The STATIC 2 function is a procedure that offsets wheel
vibrations using a single adhesive weight on a single
plane positioned exactly at 12 o’ clock.
Enter the measurements (see Par. 14.2.1) and proceed
as described in Par. 14.5 "Dynamic balancing" (only for
wheel inner side).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
14.6.4 Dynamic
The DYNAMIC program allows the wheels balancing
by fitting two clip adhesive weights: one on the outside
and one on the inside rim. Enter the measurements
(see Par. 14.2.1) and proceed as described in Par. 14.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
14.6.5 ALU-S
The ALU-S program permits balancing wheels by two
fitting adhesive weights on the outer and inner sides
of the rim. Enter the measurements (see Par. 14.2.1)
and proceed as described in Par. 14.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
1297-M021-1_B
To Next Page
