4-1 Charging Instructions 85
● During AC charging at a low temperature, to increase the charging
power, the temperature control system (if any) will be activated at this
moment, the power consumption for heating will increase when
compared with DC charging and the charging time will also extend.
These are normal phenomena for charging in a low-temperature
environment.
● To improve the vehicle driving experience, it is recommended that the
vehicle be charged immediately after being driven. At this moment,
the temperature of power battery is relatively high and the charging
performance can be improved.
● Both the performance of the battery temperature control system (if
any) and the charging performance of the vehicle will be affected if
A/C is turned on during charging at a low temperature.
■ When heating (if any) is turned on during charging, it is normal that there is
a certain delay in the charging time and the charging power will increase
slightly.
■ During charging, after the battery heating starts, it is normal that the
charging power displayed on the instrument may drop and fluctuate for a
short time.
■ Before charging is completed, to improve the battery service life, the
battery equalization function will be activated, and this may result in delay
in charging time.
The pure electric vehicle is driven by electric energy supplied from power
battery. To prevent insufficient power of the power battery affecting the vehicle
driving experience, it is very important to charge the vehicle in time and
estimate the power demand before driving.
The vehicle can be charged by three methods:
1. AC charging with household portable equipment
2. Single-phase/Three-phase AC charging through charging pile (if any)
3. DC charging through charging pile
■ The charging time of power battery varies with the charging method,
current SOC, real-time temperature, service time, ambient temperature
and other conditions.
■ Charging shall comply with the requirements of GB/T 18487.1-2015.
1. Preset charging (to charge the vehicle for a fixed period of time in
accordance with the charging time set by the user)
Refer to setting procedures of preset charging function on the combination
To Next Page
